9 Operation and use
100_0201_op_0004.fm
23
1. Firmly hold the machine by the control handle.
2. Activate the choke if the engine is cold.
3. Put the throttle lever in the IDLING position. The fuel cock opens automatically.
4. Press the purge bulb 10x until it is completely filled with fuel.
5. Pull the starter rope of the recoil starter several times until the engine starts.
6. Allow the engine to warm up.
7. The machine will start and the vibration starts in the forward direction.
9.4
Operation
Only guide and steer the machine using the control handle.
9.4.1
Compacting material
1. Guide the machine with both hands on the control handle.
2. Actuate the throttle lever until the desired rpm is reached.
3. Once the material is compacted, raise the machine and relocate.
When lifting the machine, place the throttle lever to IDLING so that the engine will continue to run
at a low rpm.
Item
Designation
Item
Designation
1
Purge bulb
3
Gas throttle lever
2
Choke
NOTICE
At full throttle, the choke will automatically disengage.
WARNING
Injuries from uncontrolled and unguided machines.
Always hold the machine with both hands and assume a secure stance.
1
2
3
Summary of Contents for BS Series
Page 50: ......
