wc_tx004193gb_FM10.fm
42
Operation
CRT48
Continued from the previous page.
Steering
The steering levers
(c)
control the travel direction and rotation of the machine.
Hand motions
Refer to the illustration for the necessary steering lever motions to move the trowel
in the desired direction.
1
— forward
2
— reverse
3
— rotate counter-clockwise
4
— rotate clockwise
5
— move left sideways
6
— move right sideways
Operating the
machine
Follow the guidelines below to use your Ride-On Trowel to its fullest capacity.
■
Operate the machine in the direction that the operator is facing. This will finish
the widest possible area, while giving the operator an excellent view of the slab
surface to be troweled.
■
When the machine reaches the end of the slab, make a 180° U-turn and repeat
the straight line of direction to the other end of the slab.
■
Alternatively, move the machine laterally (sideways) and then travel
backward to the other end of the slab.
■
Remember that the best possible control is achieved at maximum engine
speed.
NOTICE:
Do not use excessive pressure on the steering levers. Excessive
pressure does not increase the reaction time of the machine and can damage the
steering controls.
Stopping the
machine
1. Stop trowel movement by returning the steering levers to their neutral positions
and releasing pressure on the throttle foot pedal.
2. Shut off the engine by turning the key switch to “O” (OFF) position.
wc_gr013208
c
Summary of Contents for CRT48-35L
