3-14
BA 1404 en – Edition 2.7 * * 1404b330.fm
Operation
Starting with the drive interlock (option)
After you have completed the starting preparations:
☞
Approach the transponder key to about 2 cm from the emitter/receiver unit
E
☞
The machine can be started as soon as the red indicator light
L
goes out
☞
Now insert the ignition key within 30 seconds in the preheating start switch
25
and turn
the ignition key at least in position „
1
“
☞
Check whether all indicator lights illuminate:
☞
Replace malfunctioning indicator lights immediately.
☞
Turn the starting key to position “
2
” and hold it in this position for about 5 seconds
➥
The intake air is preheated
☞
Turn the starting key to position “
3
” and hold it in this position until the engine starts
➥
If the engine does not start after 10 seconds
☞
Interrupt the start procedure and try again after about 1 minute
➥
If the engine still does not start after the second try
☞
Contact a Wacker Neuson service center for troubleshooting
➥
As soon as the engine runs:
☞
Release the starting key
Starting with the drive interlock – internal transponder (option) (from serial number AG00673)
A
= operator’s key (blue key)
For starting the machine. Scope of delivery includes 2 keys.
B
= master key (red key)
Notice!
Store the master key in a safe place. It is only used for coding new keys.
All keys are deleted if the key remains in position
1
for more than 20 seconds. A
new immobilizer must be installed if the master key is lost.
Abb. 48: Immobiliser
E
L
1
0
2
3
25
Abb. 49: Preheating start switch
Abb. 50: Indicator lights
2 x
1 x
A
B
Abb. 51: Indicator lights
Summary of Contents for E09-01
Page 8: ...1 6 BA 1404 en Edition 2 7 Ba1404en2_7IVZ fm Table of contents...
Page 23: ...BA 1404 en Edition 2 7 1404b110 fm 1 13 Introduction Overview of safety labels...
Page 171: ...BA 1404 en Edition 2 7 1404b560 fm 5 43 Maintenance DIN 51 502 DIN 51 825 1000156007 1...
Page 172: ...5 44 BA 1404 en Edition 2 7 1404b560 fm Maintenance...
