BA 1404 en – Edition 2.7 * 1404b330.fm
3-51
Operation
Load the machine with the eye hooks as follows:
• Fit the standard bucket and lock it safely
• Empty the standard bucket
• Tilt in the standard bucket and lower it to transport position
• Fully raise the boom
• Pull the stick toward the machine
• Stop the engine
• Raise the control lever base
• Remove the ignition key and carry it with you
• Lock the upper carriage
• Do not allow anyone to stay in the cab, and close the doors and the engine cover
• Mount extension
A
to the lifting eyes
B
(until serial numbers AF05320 - M16 - wrench gap extension 12 mm)
(starting from serial numbers AG02423 - M20 - wrench gap extension 14 mm))
• Mount the lifting eyes to the cabin and tighten (as depicted in
)
• Use suitable lifting gear, chains, etc.
• Install the lifting gear on both eye hooks
• Ensure that the lifting gear has the required length
L1
• Slowly raise the machine
A
B
Abb. 119: Installing the eye hooks
Abb. 120: Craning operation with eye hooks
L1
L1
L1
Thread
Serial number
Torque Nm (ft.lbs)
M16
Until AF0530
70 (52)
M20
Starting from AG02423
135 (100)
Excavator
Length
Dimension
1404
L1
1200 mm (47 in)
Summary of Contents for E09-01
Page 8: ...1 6 BA 1404 en Edition 2 7 Ba1404en2_7IVZ fm Table of contents...
Page 23: ...BA 1404 en Edition 2 7 1404b110 fm 1 13 Introduction Overview of safety labels...
Page 171: ...BA 1404 en Edition 2 7 1404b560 fm 5 43 Maintenance DIN 51 502 DIN 51 825 1000156007 1...
Page 172: ...5 44 BA 1404 en Edition 2 7 1404b560 fm Maintenance...