3-80
BA 1404 en – Edition 2.7 * * 1404b340.fm
Operation
Excavator work position
Proceed as follows:
☞
Place stabilizer blade
A
on the side you want to dig
Bucket position when digging
☞
Move the bucket as shown in
A
.
➥
Move the flat side of the bucket parallel to the ground.
Notice!
Position
B
causes the bucket to penetrate into the ground. Work slows down, and the
engine and the hydraulic pump are subject to overload if this position is used over a
longer period of time!
Position
C
causes the bucket to be forced upward and not to be filled completely.
☞
Excavate as follows:
• Penetrate into the ground with bucket
D
• Lower the stick and at the same time align bucket
E
until
• reaching the required digging depth and
• the flat side of the bucket is parallel to ground
☞
Pull bucket
E
parallel to the ground toward the excavator;
if possible, at the same time:
• Move the stick toward the excavator
• Lower the boom
☞
With a sufficiently full bucket
E
:
• Keep on moving the stick toward the excavator and at the same time
• Tilt in stick
F
Excavating trenches
• Excavating trenches is more efficient
☞
by using a suitable bucket for this work and positioning the tracks parallel to the limit
line of the trench.
☞
In case of large trenches, first excavate the side sections and then the center section.
Abb. 170: Excavator work position
A
Abb. 171: Bucket position
A
B
C
Abb. 172: Penetrating into the ground with the bucket and
aligning it
D
E
Abb. 173: Filling the bucket
E
F
Abb. 174: Excavating trenches
Summary of Contents for E09-01
Page 8: ...1 6 BA 1404 en Edition 2 7 Ba1404en2_7IVZ fm Table of contents...
Page 23: ...BA 1404 en Edition 2 7 1404b110 fm 1 13 Introduction Overview of safety labels...
Page 171: ...BA 1404 en Edition 2 7 1404b560 fm 5 43 Maintenance DIN 51 502 DIN 51 825 1000156007 1...
Page 172: ...5 44 BA 1404 en Edition 2 7 1404b560 fm Maintenance...
