5-18
BA 1404 en – Edition 2.7 * * 1404b520.fm
Maintenance
Tightening the V-belt (alternator)
Caution!
Overtensioning the V-belt can damage the V-belt, the V-belt guide and the
water pump bearing.
Avoid contact of oil, grease, or similar substances with the V-belt.
☞
Checking V-belt tension
☞
Replace V-belts with damage, cracks, cuts, etc.
☞
Avoid contact of oil, grease or similar substances with the V-belt
• Retension as follows:
☞
Stop the engine.
☞
Raise the control lever base.
☞
Remove the starting key and carry it with you.
☞
Disconnect the battery or the battery master switch.
☞
Open the engine cover.
☞
Let the engine cool down.
☞
Slacken fastening screws
1
of cover
2
.
➥
Remove cover
2
.
☞
Slacken fastening screw
3
of alternator
4
.
☞
Use a suitable tool to push the alternator in the direction of arrow
A
until reaching the
correct V-belt tension
☞
Keep the alternator in this position, and at the same time retighten fastening screw
3
.
☞
Check V-belt tension again and adjust it if necessary.
☞
Tighten fastening screws
1
of cover
2
.
☞
Connect the battery or the battery master switch.
☞
Close and lock the engine cover.
Abb. 200: Tightening the V-belt
A
3
4
1
2
Summary of Contents for E09-01
Page 8: ...1 6 BA 1404 en Edition 2 7 Ba1404en2_7IVZ fm Table of contents...
Page 23: ...BA 1404 en Edition 2 7 1404b110 fm 1 13 Introduction Overview of safety labels...
Page 171: ...BA 1404 en Edition 2 7 1404b560 fm 5 43 Maintenance DIN 51 502 DIN 51 825 1000156007 1...
Page 172: ...5 44 BA 1404 en Edition 2 7 1404b560 fm Maintenance...