wc_tx004174gb_Fm10.fm
32
Machine Setup
HDR 115
Continued from the previous page.
Requirements
Position the machine so that:
■
The machine is on a flat, firm surface.
■
Burner exhaust will not enter nearby structures.
■
The machine does not block traffic.
■
The machine is not close to any combustibles or flammable vapor.
■
The machine is not exposed to high levels of dust or airborne debris.
■
All of the machine’s access doors/panels may be accessed.
■
The cord does not pose a tripping hazard, and so the cord cannot be damaged
by machines or other equipment on the job site.
■
The machine is not sitting in pooled water or deep snow.
Guidelines
Observe the following guidelines when positioning the machine for operation.
■
Installer must be familiar with all applicable laws, codes, regulations, or other
restrictions regarding installation of direct-fired radiant heaters.
■
Install wedge blocks under the wheels to prevent movement.
■
Installation must adhere to proximity restrictions.
Proximity
restrictions
The machine must be located a safe distance from any other structures, vehicles,
materials or other combustible surfaces. The following proximity restrictions apply
for all machine installations.
■
A:
From side and rear (air inlet) of heater
■
B:
From surfaces above heater
■
C:
From air outlet of heater
■
D:
From outlet to external fuel container
wc_gr013185
C
A
m
in.
B
C
D
0.76
2.03
1.02
6
30
80
40
240
A
A
B
D
Summary of Contents for HDR115
Page 6: ...Foreword HDR 115 6 wc_tx004151gb_FM10 fm...
Page 17: ...wc_si000963gb_FM10 fm 17 HDR 115 Safety Information Notes...
Page 56: ......
Page 58: ......
