5-74
BA 357-00 * 3.0 * 35700_05_Bedienung.fm
5 Operation
Loading loose material
1. Align the blade parallel with the ground.
2. Lower the loader unit to the ground. To do this,
push the joystick forward
C
.
3. Drive forward into the material.
When machine output is reduced due to too much material:
4. Raise the loader unit a little. To do this, pull the joystick backward
D
.
Loading if the material is hard to penetrate
Load as for loading loose material, but in addition:
1. Slightly tilt the bucket in and out. To do this,
move the joystick to the left
A
and right
B
.
When the bucket is full:
2. Tilt in the bucket. To do this, press the joystick to the left
A
.
3. Reverse out of the material.
4. Raise the bucket to transport position.
Fig. 151
1.
2.
C
Fig. 152
3.
4.
D
Fig. 153
A
B
1.
Fig. 154
4.
2.
A
3.
Summary of Contents for KRAMER 5055e
