Commissioning
Manually Rotating the Light Bar 6.16
53
[en-US] | 02/2023 | 5100065071 | LTV 4L/6L | Operator’s Manual
2.
If loosened, tighten the bracket nut
(1)
when the light is aimed properly.
Note:
The bracket nut should be only tight enough so that slight resis-
tance is present when aiming the fixture.
3.
Repeat steps 1 and 2 for each remaining light fixture, if desired.
6.16
Manually Rotating the Light Bar
Overview
The operator can rotate the light bar 360° while the tower is lowered. Make
sure to aim the light bar forward before towing.
Procedure
1. Loosen the mast rotation knob
(1)
.
2. Rotate the mast to the desired position.
3. Tighten the mast rotation knob .
6.17
Leveling the Trailer
WARNING
Tipping and falling hazard
Failure to level the trailer or extend the outriggers will reduce the stability of
the unit.
►
Extend the outriggers and level the trailer before raising the tower. The
outriggers must remain extended while the tower is up.
Procedure
1.
Pull the locking pin on the tongue jack
(1)
and rotate the tongue jack
down 90° as shown. Insert the pin once the jack is in position.
wc_gr013744
1
2
3
4
5
3
4
5
Fig. 27: Leveling the trailer procedure
2.
Block or chock the trailer wheels
(2)
.
3.
Crank the tongue jack down to raise the trailer tongue off the vehicle.
4.
Pull the outrigger lock pins
(3)
to release the outriggers. Pull both out-
riggers
(4)
out until you feel the lock pin snap into place.
6
Summary of Contents for LTV 4L
Page 4: ...This page is intentionally left blank...
Page 104: ...Index 104 Operator s Manual LTV 4L 6L 5100065071 02 2023 en US...
Page 105: ......
