Commissioning
6.10 Installing the Power Winch
44
Operator’s Manual | LTV 4L/6L | 5100065071 | 02/2023 | [en-US]
Installing the winch cable
1.
Pass the winch cable
(7)
over the top of the manual winch drum
(2)
and through the side hole
(8)
.
wc_gr014404
2
2
7
7
8
9
10
Fig. 18: Winch cable and components
2.
Wind the winch cable around the manual winch drum once.
3.
Loosen the nut
(9)
on the winch cable retainer
(10)
and insert the free
end of the winch cable through the winch cable retainer so approxi-
mately 2.5 cm (1 in.) of winch cable extends beyond the winch cable
retainer as shown in the illustration.
4.
Tighten the nut on the winch cable retainer to a torque of
10 Nm (7.5 ft. lbs.).
5.
Rotate the manual winch clockwise to take up any slack in the winch
cable.
6.10
Installing the Power Winch
Materials needed
• Power winch
• Hardware bag 7
Installing the power winch
1.
Remove the cover
(1)
from the power winch
(2)
.
Summary of Contents for LTV 4L
Page 4: ...This page is intentionally left blank...
Page 104: ...Index 104 Operator s Manual LTV 4L 6L 5100065071 02 2023 en US...
Page 105: ......
