Commissioning
7.2 Mounting the guide bracket
32
Operator’s Manual | WP | 5100069895 | 01/2023 | [en-US]
Operation on inclined surfaces
NOTICE
Technical damage due to failure of engine lubrication!
►
Do not exceed the maximum permissible inclination, see
.
• Only approach gradients from below.
Ground conditions
The maximum dumping height depends on several factors of the ground
conditions. An exact specification of this value is not possible.
▪
Determine the maximum fill height by compaction tests or soil sam-
ples.
Shaking in cobblestones
▪
To avoid damage to the machine or compaction material, use a slid-
ing device,
.
Compaction of asphalt
▪
To avoid cracking and sticking to the asphalt, use water tank with
sprinkler system,
.
7.2
Mounting the guide bracket
2
3
1
2
1.
Unscrew screws
1
and bushings
2
on both sides of the machine.
2.
Attach bushings to the guide bracket
3
.
3.
Position guide bracket correctly.
4.
Screw in screws on both sides.
5.
Tighten the screws. Tightening torque 60 Nm.
ð
The machine is ready for operation.