59
59
WIRELESS SETUP
Configure Bamboo for wireless operation.
1. If you have been using Bamboo as a wired tablet, disconnect the USB cable.
2. Turn the tablet over. Remove the wireless compartment cover(s). See (A).
Slide cover(s) away from tablet body to remove. The large Bamboo tablet is
equipped with two covers: one for the Wacom wireless module, and one for
the rechargeable battery.
3. Install the wireless components.
4. If you have not already done so, turn on your computer and wait until the system has fully loaded.
Next, connect wirelessly.
Establishing a wireless connection
Optimizing the wireless connection
A
•
Install the battery. Align contacts (B) as
shown and press into place. See also
•
Install the wireless module. Lift away and
remove the wireless module spacer (C). Slide
the wireless module into the tablet, ensuring
the connector is fully seated (D).
Important: Save the module spacer.
You may need it as a tool for removal of
the wireless module, and to protect the
tablet interior from dust when the module
is not installed. See
.
•
Replace the wireless compartment cover(s).
Align and slide into place (E).
•
Connect the Wacom wireless receiver to an
active USB port on your computer or USB
hub (F).
When not in use, store the receiver in the
wireless receiver storage compartment.
See
B
C
D
E
F