INSTALLATION
Page 11
LCD MONITOR CABLING DIAGRAM
DTU-710, Rear View
– C –
DC
IN
Analog
– A –
Digital
D
IGITAL
/A
NALOG
(DVI/VGA) Switch
DVI to DVI Cable
Or...
DVI to VGA Cable
Video card
DVI or VGA
Rear panel of your computer
DVI Connector
Do not attach the
USB data cable until
instructed to do so.
Power Adaptor
– D –
To AC Outlet
C
AUTION
Do not use any cable that did not come with the DTU-710;
use of an improper cable
may damage the unit.
Make sure your video card has a DVI or VGA connector, and that you correctly
set the DTU-710 D
IGITAL
/A
NALOG
(DVI/VGA) switch for the video card you are using.
The use of an improper video card may damage the DTU-710.
Do not connect or disconnect the video or power cables while the DTU-710 or your
computer are turned on –
this can damage the LCD monitor or computer video card.
Do not exceed a display refresh rate of 75 Hz –
this can overheat the LCD monitor and
cause permanent damage.
– B –
DTU-710_Manual.fm Page 11 Monday, August 30, 2004 3:49 PM