INSTALLATION
Page 13
STEP 2: PEN TABLET INSTALLATION
USB CABLE INSTALLATION
•
Plug the square end of the USB cable into the DTU-710 port labeled USB. Plug the other end into
an available USB port on your computer or on a USB hub attached to your computer. See
– E –
in
the connection diagram below.
Note:
For Windows 98SE, the A
DD
N
EW
H
ARDWARE
W
IZARD
will display. Follow the prompts,
selecting the default options. If prompted to install drivers for the USB Human Interface Device,
insert the Windows 98SE CD, click OK, and enter the location of the Windows CAB files
(e.g.,
D
:\
WIN
98).
•
Insert the three cables between the cable guides and then slide the connector panel cover into
place over the cable connectors on the rear of the DTU-710.
PEN TABLET CABLING DIAGRAM
C
AUTION
Do not connect or disconnect the video or power cables while the DTU-710 or your
computer are turned on –
this can damage the LCD monitor or computer video card.
DTU-710, Rear View
Cable Guides
To USB port.
Your computer.
– E –
This port is not required for standard operations
and requires an optional serial data cable.
USB port
To video connection. See page 10.
To power adaptor. See page 10.
DTU-710_Manual.fm Page 13 Monday, August 30, 2004 3:49 PM