INTERACTIVE PEN DISPLAY COMPONENTS
Page 6
INTERACTIVE PEN DISPLAY COMPONENTS
The LCD monitor and tablet sensor function as an integrated input and output device. The LCD monitor
supports resolutions up to 1280 x 1024 pixels at 16.2 million colors. The tablet sensor reports pen
coordinates, pressure, switch, and eraser information.
FRONT VIEW
On Screen Display (OSD) Controls
These controls enable you to adjust a variety
of display settings. See
Adjusting the LCD
Monitor
on page 23 for more information.
Power LED
Lights blue when power has been supplied to both the
DTU-710 and the computer and a video signal is
present.
Glows orange when no video signal is detected by the
DTU-710. (e.g., Your computer is turned off, starting up,
or has entered a power management mode in which
video signals are not sent.)
Power Switch
Turns power to
the unit on or off.
Status LED
Lights blue when the pen is in the active area of the
pen display tablet and the pen tip or side switch are
pressed. Also lights blue when the pen eraser is
brought within 5 mm (0.2 inch) of the pen display
tablet screen and stays blue when the eraser is
pressed. Note that the USB cable must be plugged
into an active USB port before the LED will light.
Integrated LCD Monitor and Tablet
DTU-710_Manual.fm Page 6 Monday, August 30, 2004 3:49 PM