61
61
Interactive pen display
USING AN ALTERNATE MOUNT OR STAND
If you will be using the interactive pen display in an installation that requires the use of an alternate
mounting platform, you can remove the adjustable stand from the unit and mount the pen display onto any
mount arm or stand conforming to the VESA standard.
For model DTU-2231 the mount arm or stand must conform to the VESA 100 mm standard.
For model DTU-1631 the mount arm or stand must conform to the VESA 75 mm standard.
Mounting screws that are 4 mm wide with a 0.7 mm pitch (M4 Regular), with a screw clearance depth of
15 mm are required. Exceeding the clearance depth of 15 mm will damage the internal components of the
pen display.
To remove the adjustable stand and attach the pen display
to a different mounting platform:
1. Turn off your computer and power off the pen display.
Then disconnect all cables from between the unit and
your computer.
2. Protect the display screen surface by spreading a soft
cloth onto a flat table and placing the pen display face
down on the cloth.
3. Remove the four screws and lift the adjustable stand
assembly away from the body of the unit.
4. Using the appropriate screws for your mounting
platform, firmly attach the pen display to the alternate
mounting platform.
5. Refer to the
instructions and reattach the
cabling.
Caution
When attaching the pen display onto an alternate
mounting platform, be sure to follow all instructions in
the documentation supplied by the platform
manufacturer. If improperly installed, the unit could
fall, resulting in damage to the unit or physical injury.
