Page 120
•
Then press the tool’s eraser to the tablet—the S
WITCHES
state and P
RESSURE
value will change.
(P
RESSURE
should change from approximately 0% with no pressure applied to approximately 100%
when full pressure is applied.)
•
For the airbrush, move the fingerwheel forward—the W
HEEL
value should decrease to a value of
approximately 0 when the fingerwheel is all the way forward. Move the fingerwheel backward—the
W
HEEL
value should increase to approximately 1000 when the fingerwheel is all the way back.
4. Test tilt for the x-axis by moving the Intuos Pen or Airbrush from a vertical position toward the right; the
X T
ILT
value should change from approximately 0 to +60 (0 to +50 for Intuos 4x5 tablets). Now move
the tool to the left of vertical; the X T
ILT
value should change from approximately 0 to -60 (0 to -50 for
Intuos 4x5 tablets).
5. Test tilt for the y-axis by moving the Intuos Pen or Airbrush from a vertical position toward the bottom of
the tablet; the Y T
ILT
value should change from approximately 0 to +60 (0 to +50 for Intuos 4x5 tablets).
Now move the tool toward the top of the tablet; the Y T
ILT
value should change from approximately 0 to
-60 (0 to -50 for Intuos 4x5 tablets).
6. When you are done, click on the C
LOSE
button to exit the dialog box.
