Map your device to your display(s)
In Mapping settings, you can customize how the surface of your device maps to your display(s). The mapping options
available to you depend on whether you are using a single display or multiple displays.
on In Mapping settings. This is useful if you notice that drawings look distorted
and different than what you are drawing with your pen on your Wacom device.
Warning:
If you change the display properties in your computer's display menu, you are also
changing the settings on the Mapping page.
Map your device to a portion of a single display
Map your device to a portion of multiple displays
Map your device to one of multiple displays
Use a portion of your device's active area
Map your device to a portion of a single display
Note:
These instructions apply to single display setups only.
If you only have one display, your Wacom device will be mapped to the full display by default. To change it to a
portion, follow the instructions below.
1.
.
2. Select your device from the
.
3. Select
Mapping
.
4. Under
Display mapping
, choose "Select portion..."
5. In the
Map a portion of your screen setup
window, use any of the following methods to map your device to
a portion of your screen displays:
Use the drag handles to drag the corners of the blue border to define the screen area that you want to
map to.
Select
Click to define
and use your cursor to select the screen area that you want to map to.
Enter the
Top, Bottom, Left,
and
Right
coordinates in pixels.
Tip:
To change the setting back to the full display, choose "Map to full display" under
Display
mapping
.
Map your device to a portion of multiple displays
If you have multiple displays, your Wacom device will be mapped to all of the displays by default. If you wish to map
your device to only a portion of the displays, follow the instructions below.
User's Manual
70
70
