Instruction Booklet - D4000 and D5000 Series Omnidirectional
3
ASSEMBLY
1. Loosen the clamping screws on the antenna. See mounting detail.
2. Pull downleads up through the mounting pipe and make the
connection to the antenna.
3. If grounding your equipment, do so at this time by following
the Safety Precautions procedure.
4. Slide the clamping end of the antenna onto the mounting pipe.
5. Alternately secure the clamping screws making sure to keep the
mounting pipe centred with the antenna.
6. After final tightening, lock clamping screws into position using the
supplied stainless steel hex nuts.
ANTENNA
(5000 Series shown)
CLAMPING SCREW
MOUNTING PIPE
(MAST)
ANTENNA ASSEMBLY
MOUNTING DETAIL
(4000 Series shown)
CLAMPING
SCREW
MOUNTING PIPE
(MAST)
GROUND WIRE
S.S. LOCK NUT
ANTENNA
DOWNLEADS
CENTER (VHF)
GROUND LUG
(4000 SERIES ONLY)
LOWER (UHF)
UPPER (UHF)
4
5
ANTENNA ASSEMBLY
Loosen the clamping screws on the antenna. See mounting detail.
1.
Pull downleads up through the mounting pipe and make the
2.
connection to the antenna.
If grounding your equipment, do so at this time by following the Safety
3.
Precautions procedure.
Slide the clamping end of the antenna onto the mounting pipe.
4.
Alternately secure the clamping screws making sure to keep the
5.
mounting pipe centred with the antenna.
After final tightening, lock clamping screws into position using the
6.
supplied stainless steel hex nuts.
Assembly
