Die Cut Tape.
If you are using die-cut (gap labels) feed the tape forward or print two test labels to allow the printers internal
auto sensor function to align the tape correctly.
This procedure is required only when the Printhead is unclamped and lifted clear of the tape.
If you are experiencing problems with the tape gap alignment first check the sensor positioning (see below)
then try an auto sensing calibration.
Sensor Adjustment for use with die cut tape only.
Tape Centring
Getting the tape centred correctly will ensure that the label sensing function operates correctly.
8
Align the arrow
on the sensor
centrally to the
cut-out
.
Turn off the printer
Press and hold the printers PAUSE key (located on the top control panel of the printer) and turn on
the printer until the buzzer beeps 3 times.
The printer will now go in to auto sensing mode and detect the label gap length.
Auto sensing Calibration
Ensure that the label roll
holder side plates are located
centrally on the spool & that
the side plates are not too
tightly pressed into the side of
the tape to cause any
restriction of movement.
