20
sensitivity of your system so that critical listening will take place with the volume
control operating near the top of its range. Critical listening should be done when
the 4th or higher LED is lit. The maximum out level of the Wadia 121Decoding
Computer is adjustable by means of a series of IR commands issued from the
Wadia remote control. The Wadia 121Decoding Computer output level is factory
set to accommodate the most common range of system sensitivity. If you find
that your typical volume level during critical listening is below the 3rd LED on
the LED display, it will be advantageous to use a different setting. To change
the output level use the following remote control sequence:
1 Press the four step command
PLAY
➔
PLAY
➔
PLAY
➔
PLAY
. The current
output level is displayed on the top three Volume LEDs. The three LEDs
correspond to 4.0v, 2.0v, and1.0v.
2 Press
PLAY
to move the output level to a higher setting or press
PLAY
to
adjust the output level to a lower setting.
3 Press
PLAY
again to set the desired reference voltage level.
4 Ramp the volume up to listening level to test for correct setting.
If current volume is greater than 50%, it will decrease to 50% when
configuring the speaker level.