3
3. Reinstall the Battery Cover.
4. Store the battery in a cool dry place for future use
or dispose of the battery in accordance
with the local regulations for lithium bat-
tery disposal. Batteries should never be
thrown away or incinerated.
The Wadia 321 Remote Control uses a long life Lith-
ium Coin Cell type battery. The 321 may be supplied
with a battery depending on the country where the 321
is purchased. When purchasing a battery for use in the
321 refer to the following list:
Approved Lithium Batteries
Brand
IEC No.
ANSI/NEDA No.
Energizer
CR2032
1
5004LC
1
Panasonic
CR2032(PA/1B)
1
5004LC
1
1
CR Lithium Coin Cells contain Perchlorate Material - special handling
may apply. For additional information go to www.dtsc.ca.gov/hazaedous
waste/perchlorate/index.cfm
Access to the recessed battery compartment is located
on the Rear of the Remote Control.
Refer to figure 1.
Perform the following steps to install
the battery:
1. Press the tab towards the bottom
edge of the Remote Control and
lift up on the Battery Cover and
temporarily place it aside. Refer to
figures 2 and 3.
The life of the Lithium Battery used in the Wadia
Remote Control is dependent on the actual amount of
use. It is advisable to remove the battery from the Re-
mote Control when it is not to be used for an extended
period of time. This will help to extend battery life
and avoid possible damage to the Remote Control.
Perform the following steps to remove the battery
from the Remote Control:
1. Press the tab and lift up on the Battery Cover
and temporarily place it aside. Refer to figures 2
and 3.
2. Refering to figure 6,
press on the bottom edge
of the battery to release
the battery from the
molded battery socket.
Then remove the bat-
tery from inside of the
Remote Control.
2. Remove the CR2032 Battery from its packaging.
3. Orient the battery so the + symbol (engraved into
one side of the battery) is facing up.
4. Refering to figures 4 and 5, insert the battery into
the socket. Make sure the battery is touching both
contact points and is seated in the socket.
5. Reinstall the Battery Cover.
6. The Remote Control is now ready for operation.
Battery Installation and Replacement
Battery Installation
Battery Removal
CAUTION:
Danger of explosion if the battery is in-
correctly installed. Only install one of the
approved Lithium Batteries listed below.
Figure 1
Battery
Compartment
Figure 2
TAB
Figure 3
LIFT
UP
Figure 5
CR
2032
CR2032
3V
Figure 4
CR
2032
Contact
Points
Battery
WARNING
DO NOT INGEST BATTERY, CHEMICAL BURN HAZARD
This product contains a coin/button cell battery. If the
coin/button cell battery is swallowed, it can cause se-
vere internal burns in just 2 hours and can lead to death.
Keep new and used batteries away from children. If the
battery compartment does not close securely, stop us-
ing the product and keep it away from children. If you
think batteries might have been swallowed or placed
inside of the body, seek immediate medical attention.
Figure 6
