Wadia di322, Owner'S Manual

3

3. Reinstall the Battery Cover.

6WRUHWKHEDWWHU\LQDFRROGU\SODFHIRUIXWXUHXVH

or dispose of the battery in accordance 
with the local regulations for lithium bat-
tery disposal. Batteries should never be 
thrown away or incinerated.

The Wadia di322 Remote Control uses a long life 

/LWKLXP&RLQ&HOOW\SHEDWWHU\7KHGLPD\EH

supplied with a battery depending on the country 
where the di322 is purchased. When purchasing a bat-
tery for use in the di322 refer to the following list:

Approved Lithium Batteries

Brand

,(&1R

$16,1('$1R

Energizer

CR2032

/&

1

Panasonic

&53$%

1

/&

1

1

&5/LWKLXP&RLQ&HOOVFRQWDLQ3HUFKORUDWH0DWHULDOVSHFLDOKDQGOLQJ

may apply. For additional information go to www.dtsc.ca.gov/hazaedous 
waste/perchlorate/index.cfm

Access to the recessed battery compartment is located 
on the Rear of the Remote Control. 
Refer to figure 1.
Perform the following steps to install 
the battery:

1. Press the tab towards the bottom 

edge of the Remote Control and 
lift up on the Battery Cover and 
temporarily place it aside. Refer to 
figures 2 and 3.

7KHOLIHRIWKH/LWKLXP%DWWHU\XVHGLQWKH:DGLD

Remote Control is dependent on the actual amount of 
use. It is advisable to remove the battery from the Re-
mote Control when it is not to be used for an extended 
period of time. This will help to extend battery life 
and avoid possible damage to the Remote Control.
Perform the following steps to remove the battery 
from the Remote Control:

1. Press the tab and lift up on the Battery Cover 

and temporarily place it aside. Refer to figures 2     
and 3.

2. Referring to figure 6, 

press on the bottom edge 
of the battery to release 
the battery from the 
molded battery socket. 
Then remove the bat-
tery from inside of the 
Remote Control.

2. Remove the CR2032 Battery from its packaging.
3. Orient the battery so the + symbol (engraved into 

RQHVLGHRIWKHEDWWHU\LVIDFLQJXS

4. Referring to figures 4 and 5, insert the battery 

LQWRWKHVRFNHW0DNHVXUHWKHEDWWHU\LVWRXFKLQJ

both contact points and is seated in the socket.

5. Reinstall the Battery Cover.
6. The Remote Control is now ready for operation.

Battery Installation and Replacement

Battery Installation

Battery Removal

CAUTION:

Danger of explosion if the battery is in-
correctly installed. Only install one of the 
approved Lithium Batteries listed below.

Figure 1

Battery
Compartment

Figure 2

TAB

Figure 3

LIFT
 UP

Figure 5

C

R2032

CR2032

3V

Figure 4

C

R2032

Contact
Points

Battery

WARNING

DO NOT INGEST BATTERY, CHEMICAL BURN HAZARD

The remote control supplied with this product contains 
a coin/button cell battery. If the coin/button cell battery 
is swallowed, it can cause severe internal burns in just 
2 hours and can lead to death. Keep new and used bat-
teries away from children. If the battery compartment 
does not close securely, stop using the product and keep 
it away from children. If you think batteries might have 
been swallowed or placed inside of the body, seek im-
mediate medical attention.

Figure 6