CoolMatic CRF-50
Setting up and connecting the freezer
25
5.1
Control elements
6
Setting up and connecting the freezer
Safety instructions for installation on boats
Please note the following instructions for installation on boats:
z
The device can be tilted sideways up to 30°. When setting up
the freezer, note that it must be fastened to take account of this.
If you have any questions regarding installation, consult your
specialist dealer.
z
Install the freezer so that the warm air produced can easily flow
away (either upwards or to the sides, fig.
3
, page 4).
z
The appliance is designed for ambient temperatures between
+18 °C and +32 °C.
z
If the appliance is powered by the mains, ensure that the power
supply has a residual current circuit breaker.
z
Observe all the other installation instructions in this section.
6.1
Installing the freezer
In continuous operation, the air humidity may not exceed 90%.
Set up the fridge in a dry, sheltered place. Avoid placing it near heat sources
such as radiators, gas ovens or hot water pipes. Do not let it stand in direct,
strong sunlight.
The cooling device must be positioned so that heated air can dissipate easily.
Therefore make sure there is adequate ventilation (fig.
3
, page 4).
No. in
fig.
2
,
page 3
Explanation
A
Temperature controller
No. in fig.
3
,
page 4
Explanation
1
Hot waste air
2
Cold intake air
3
Condenser
4
With decorative panel 50 mm space at the top!
CRF-50.book Seite 25 Montag, 27. September 2010 4:18 16
