Setting up and connecting the freezer
CoolMatic CRF-50
26
6.2
Releasing the lock
The freezer has a locking mechanism (
4
1, page 4) which is also used to
protect it during transport. The following settings are possible:
Caution
Only adjust the locking mechanism when the door is open. If you
use it with the door closed, you will damage the device.
z
Lock
(turn wheel clockwise to the end stop): The door is closed and
locked.
To open the door, lift the handle up and open the door.
z
Vent
(turn wheel anti-clockwise to the end stop): The door is slightly open
and fixed in place.
Use this position, if you are not going to use the appliance for a long time.
6.3
Changing the door hinge
You can also change the hinge of the door, so that it opens to the left rather
than the right.
➤
Proceed as shown in
5
, page 5 to
7
, page 5, to change the hinges.
Connecting to a battery
The freezer can be operated with a 12 V to 24 V DC voltage supply.
To prevent voltage and power losses, the cable should be as
short as possible and not be interrupted.
For this reason avoid additional switches, plugs or socket strips.
➤
Determine the required cross section of the cable in relation to the cable
length according to
8
, page 6.
Key for
8
, page 6
Caution!
Make sure that the polarity is correct.
z
Before starting up the appliance for the first time, check whether the op-
erating voltage and the battery voltage match (see type plate).
Co-ordinate axis
Meaning
Unit
l
Cable length
m
∅
Cable cross section
mm²
CRF-50.book Seite 26 Donnerstag, 13. Dezember 2007 12:19 12
www.busse-yachtshop.de | info@busse-yachtshop.de
