Using the refrigerator
HDC-190, HDC-220
28
➤
Leave the door slightly open.
This prevents odours from building up.
Locking the refrigerator
You can lock the refrigerator, to prevent children accessing it, for example.
To do this you need to glue on a security bolt and hook.
The surfaces to be bonded must be clean and dry.
To glue on the security bolt and hook, proceed as follows:
➤
Remove the protective paper from the hook.
➤
Press the self-adhesive hook firmly onto the side edge of the door (
4
,
page 4), if possible out of the reach of children.
➤
Remove the protective paper from the bolt.
➤
Hold the security bolt over the hook.
The hook must fit into the opening of the bolt and it must not be possible
to open the door if the bolt is shut (
5
, page 4).
➤
Press the self-adhesive label firmly onto the side wall of the refrigerator.
➤
To
open
the refrigerator push the security bolt to the side.
➤
To
close
the refrigerator push the door shut.
The security bolt latches in place automatically.
Changing the door hinge
You can also change the hinge of the door, so that it opens to the left rather
than the right.
To change the door hinge, proceed as follows (
6
, page 5):
➤
Remove the bolt of the lower hinge and the lower hinge (
6
1, page 5).
➤
Take off the lower door.
➤
Remove the closing mechanism on the bottom of the door (
6
2, page 5).
➤
Insert the locking mechanism on the left side again (
6
3, page 5).
➤
Remove the marked covers on the top of the door (
6
4, page 5).
➤
Remove the middle hinge (
6
5, page 5).
➤
Take off the top door.
➤
Remove the bolt of the top hinge (
6
6, page 5).
➤
Pull the pins (
6
7, page 5) out of the profile (
6
8, page 5).
hdc190-220.book Seite 28 Montag, 27. September 2010 3:40 15
