COOLMATIC CR Series
Installing and connecting the refrigerator
41
➤
Choose the condensation outlet most suitable for the place of installation
and remove its cap.
➤
Insert a sharp object (e.g. a screwdriver) approx. 25 to 30 mm into the
outlet to pierce open the inside of the appliance.
If you put the refrigerator in a recess, you can fix it inside with suitable
screws:
➤
Remove the blanking plugs (fig.
7
2, page 6).
➤
Push the refrigerator into the recess.
➤
Use suitable screws (fig.
7
1, page 6) to fix the refrigerator in place.
➤
Press the blanking plugs (fig.
7
2, page 6) into the openings.
7.2
Undo the lock
The refrigerator has a locking mechanism (fig.
9
1, page 6) which is also
used, to protect it during transport. The following settings are possible:
a
Caution
Only adjust the locking mechanism when the door is open. If you
use it with the door closed, you will damage the device.
z
Lock
(turn wheel clockwise to the end stop): The door is locked and
secured.
To open the door, lift the handle up and open it.
z
Vent
(turn wheel anti-clockwise to the end stop): The door is slightly open,
but fixed in position.
Use this position, if you are not going to use the appliance for a long time.
7.3
Changing the door hinge
You can also change the hinge of the door, so that it opens to the left rather
than the right.
➤
Proceed as shown in fig.
b
, page 8 to fig.
d
, page 8, to change the
hinges.
_cr-kuehlschraenke.book Seite 41 Montag, 6. April 2009 1:03 13
