Maintaining and cleaning MAGIC WATCH
magic watch
44
9
Maintaining and cleaning
MAGIC WATCH
Caution!
Do not use sharp or hard objects to clean the device as these may
damage the sensors.
➤
Clean the sensors with a damp cloth from time to time.
10
Searching for errors
The device indicates no function.
The cables to the reversing light are not connected or are switched.
The plug for the display is not connected or is not properly plugged into the
control electronics.
The plugs for the sensors are not connected or are not properly plugged into
the control electronics.
➤
Check the plugs, and plug them in so that they latch in place.
A defective sensor is indicated (three beeps when you engage reverse
gear)
If a defective sensor is indicated (see “Testing functions” chapter on
page 42), this is what to do:
➤
Park the vehicle about a metre away from a large obstacle, such as a
garage door.
➤
Engage reverse gear.
✓
The slow beeps sound (Zone 1, see fig. 5, page 5) and the green LEDs of
the intact sensors light up.
➤
Then stand in front of each sensor in succession.
✓
The beeps speed up. The beeps do
not
change on the defective sensor.
MWE-850-4DSM.book Seite 44 Donnerstag, 7. Juli 2005 2:39 14
Summary of Contents for Magic Watch MWE-850-4DSM
