MagicWatch MW650
Installing MagicWatch
37
Caution!
Before making any drill holes, ensure that no electrical cables or
other parts of the vehicle can be damaged by drilling, sawing and
filing.
➤
Take suitable precautions to protect holes made in the bodywork from
water penetration, for example by spraying the cable and the sleeve with
sealant.
➤
Where possible, use existing rubber bungs in the boot for laying the
extension cables.
If there are no rubber bungs, make a suitable hole with a diameter of
around 13 mm and insert a cable sleeve.
Note
Pull the plugs of the extension cables through the cable sleeve
before inserting the sleeve in the body work.
➤
Lay out the cables so that they cannot be damaged under any circum-
stances (e.g. by flying grit).
➤
Carefully fasten the extension cables behind the bumper.
➤
Insert the sensor plugs into the sockets of the corresponding extension
cables (see fig. 15 A, page 7).
MW-650-4DSM.book Seite 37 Dienstag, 16. Mai 2006 4:28 16
Summary of Contents for MagicWatch MW650
Page 3: ...MagicWatch MW650 3 1 2 3 4 9 6 8 5 7 1 MW 650 4DSM book Seite 3 Dienstag 16 Mai 2006 4 28 16...
Page 4: ...MagicWatch MW650 4 4 1 3 5 6 2 4 2 3 MW 650 4DSM book Seite 4 Dienstag 16 Mai 2006 4 28 16...
Page 8: ...MagicWatch MW650 8 2 3 31 1 17 MW 650 4DSM book Seite 8 Dienstag 16 Mai 2006 4 28 16...
