MagicWatch MWE150
Installing MagicWatch
33
6.3
Laying the sensor extension cables
When laying cables, ensure that:
z
They are not kinked or twisted
z
They do not rub on edges
z
They are not laid in sharp edged ducts without protection (
3
, page 4).
Note
The extension cables are marked: L (left) and R (right).
This marking helps you connect them to the control electronics.
Caution!
Before making any drill holes, ensure that no electrical cables or
other parts of the vehicle can be damaged by drilling, sawing and
filing.
➤
Take suitable precautions to protect holes made in the bodywork from wa-
ter penetration, for example by spraying the cable and the sleeve with
sealant.
➤
Where possible, use existing rubber bungs in the boot for laying the ex-
tension cables.
If there are no rubber bungs, make a suitable hole with a diameter of
around 13 mm and insert a cable sleeve.
Note
Pull the socket connectors of the extension cables through the
cable sleeve before inserting the sleeve in the body work.
➤
Lay out the extension cables in the boot so that they cannot be damaged
under any circumstances (e.g. by flying grit).
➤
Carefully fasten the extension cables behind the bumper.
➤
Insert the sensor plugs into the sockets of the corresponding extension
cables (
c
A, page 7).
MWE-150-2.book Seite 33 Freitag, 3. Februar 2006 4:52 16
Summary of Contents for MagicWatch MWE150
Page 3: ...MagicWatch MWE150 3 1 2 3 4 9 6 8 5 7 1 MWE 150 2 book Seite 3 Freitag 3 Februar 2006 4 52 16...
Page 4: ...MagicWatch MWE150 4 2 3 5 1 4 4 2 3 MWE 150 2 book Seite 4 Freitag 3 Februar 2006 4 52 16...
Page 174: ...MWE 150 2 book Seite 174 Freitag 3 Februar 2006 4 52 16...
Page 175: ...MWE 150 2 book Seite 175 Freitag 3 Februar 2006 4 52 16...
