Using the charger
IU6, IU8, IU12
34
5.3
Battery terminals and cables
The cables can be wrapped around the feet of the device for stor-
age.
The battery terminals (fig.
8
1, page 5) and the mains plug
(fig.
8
2, page 5) can be stored in the back of the device.
6
Using the charger
d
Warning – danger of explosions!
Batteries with a cell short circuit may not be charged. There is a
danger of explosions due to oxyhydrogen gas.
Nickel-cadmium batteries and non-rechargeable batteries may not
be charged with the charger. The sleeves of these batteries can
burst in an explosive manner.
6.1
Connecting the charger
a
Caution – risk of damage
The charger must be installed in a place that is protected from
moisture and humidity.
Make sure:
– No flammable materials or gases are in the vicinity.
– The installation location is well ventilated.
– The installation surface is flat and sufficiently firm.
Make sure the mains cable and connecting cables to the battery
are not stretched, kinked or resting on sharp edges.
The air intake and outlet openings of the charger must be kept
clear.
➤
Disconnect the car battery from the vehicle electrics before
charging to prevent
consumers
from affecting the charging
process: Disconnect the negative terminal before the positive
terminal.
_IU6_IU8_IU12_BA_10s.book Seite 34 Mittwoch, 16. Januar 2008 2:06 14
Summary of Contents for PerfectCharge IU6
Page 3: ...IU6 IU8 IU12 3 1 2 5 3 4 _IU6_IU8_IU12_BA_10s book Seite 3 Mittwoch 16 Januar 2008 2 06 14...
Page 4: ...IU6 IU8 IU12 4 A B 6 _IU6_IU8_IU12_BA_10s book Seite 4 Mittwoch 16 Januar 2008 2 06 14...
Page 5: ...IU6 IU8 IU12 5 1 2 3 7 1 2 8 _IU6_IU8_IU12_BA_10s book Seite 5 Mittwoch 16 Januar 2008 2 06 14...
