PerfectCharge IU812
Fitting the automatic charger and putting it into service
19
5.1
Device components
6
Fitting the automatic charger and
putting it into service
a
Caution!
The IU0U automatic charger must be installed in a place that is
protected from moisture and humidity.
Make sure:
– The installation location is well ventilated.
– The installation surface is flat and sufficiently firm.
The air intake on the underside and the air outlet on the back of the
IU0U automatic charger must be kept clear.
e
Warning!
Disconnect the mains plug before connecting or disconnecting the
DC voltage connection.
e
Warning!
Batteries with a cell short circuit may not be charged. There is a
danger of explosions due to the explosive gases.
Nickel-cadmium batteries and non-rechargeable batteries may not
be charged with the IU0U automatic charger. The sleeves of these
batteries can burst in an explosive manner.
e
Warning!
To connect the IU0U automatic charger only use cables
not longer
than 2 m with a cross section of 1.5 mm² or more.
Item
in fig.
1
, page 3
Meaning
1
Fuse insert with glass fuse 10 A/250 V
2
“Power” indicator lamp
3
“Charging” indicator lamp
4
Connection terminal
5
Mains power cable (230 V)
808-012.book Seite 19 Freitag, 12. Dezember 2008 7:54 19
