Using the battery charger
PerfectCharge W20
21
5.2
Providing jump starts
Connect the battery as follows:
➤
Make sure that the device is
not
connected to the 230-V mains connec-
tion.
➤
Set the
B
switch (Fig. 8, page 3) to “Start”.
➤
Connect the red plus clamp of the battery charger to the positive pole (+)
of the battery (see Fig. 6, page 2).
➤
Connect the black minus clamp of the battery charger to the negative pole
(-) of the battery (see Fig. 7, page 3).
➤
Now plug the mains plug into an earthed and properly fuse-protected
230-V mains socket.
If you are uncertain, consult a specialist.
✓
The ammeter (Fig. 8 E, Page 3) points to “Start”.
➤
Determine whether you are starting a vehicle with a 12-V or 24-V battery.
➤
Set the
A
switch (Fig. 8, page 3) to
– “70 A/7.2 V” for a 12-V battery
– “35 A/14.4 V” for a 24-V battery
✓
You can now start the vehicle.
Unclamping the battery charger
Caution!
When unclamping the battery charger, make sure
not
to cause a
short-circuit.
➤
When the starting procedure is finished, pull the 230-V mains plug from
the socket.
➤
Unclamp the black minus clamp of the battery charger.
➤
Unclamp the red plus clamp of the battery charger.
MBC-2000.book Seite 21 Donnerstag, 24. November 2005 3:51 15
