Installing the rear view video camera
PerfectView CAM16
30
When mounting the camera, proceed as follows:
➤
Hold the housing holder on the chosen location and mark at least two different points
for the drill holes (
8
, page 7).
If you would like to screw the camera on with self-tapping screws (
9
, page 7).
The holder may only be attached to steel panels with a minimum thickness of
1.5 mm using self-tapping screws.
➤
Using a hammer (
1
6, page 3) and centre punch (
1
5, page 3), gently pre-punch
the previously marked points to prevent the drill head from slipping off.
➤
Drill Ø 3 mm holes at the points you have just marked.
➤
Deburr all drill holes and apply rust-protection.
➤
Screw the housing holder on with the 4 x 25 mm self-tapping screws.
If you would like to attach the camera with threaded screws fitted through the
body shell (
0
, page 7)
Ensure that that nuts cannot be pulled through the body shell when they are
tightened.
➤
Using a hammer and centre punch, gently pre-punch the previously marked points to
prevent the drill head from slipping off.
➤
Drill Ø 4.5 mm holes at the points you have just marked.
➤
Screw the housing holder on with the M4 x 25 mm threaded screws.
Creating a through-hole for the camera connection cable
If possible, use available openings – such as ventilation grilles – to feed the
connection cables through. If there are no existing openings, you must drill a
hole with a 13 mm diameter. Check beforehand that there is sufficient room for
the drill head to come out on the other side.
➤
Drill a hole of Ø 13 mm near the camera (
a
, page 7).
➤
Deburr all drill holes that have been made in the sheet metal and apply rust-
protection.
➤
Place cable sleeves in all sharp edged ducts.
Mounting the camera in the housing
➤
Push the camera into the aluminium housing (
b
, page 7).
➤
Make sure that the camera is aligned correctly. A green sticker on the camera indi-
cates the correct position.
➤
Push the camera housing under the housing holder and lock the knurled nuts against
each other.
➤
Fasten the camera housing with the four screws (
c
, page 8) but do not tighten them
fully yet.
➤
Tighten the screws when you have aligned the camera (see “Checking the function
and setting the camera” chapter on page 32).
_RV-16.book Seite 30 Freitag, 13. April 2007 2:33 14
Summary of Contents for PerfectView CAM16
Page 4: ...PerfectView CAM16 4 2 3 _RV 16 book Seite 4 Freitag 13 April 2007 2 33 14...
Page 5: ...PerfectView CAM16 5 4 3 1 2 4 _RV 16 book Seite 5 Freitag 13 April 2007 2 33 14...
Page 7: ...PerfectView CAM16 7 9 a 0 8 b _RV 16 book Seite 7 Freitag 13 April 2007 2 33 14...
Page 8: ...PerfectView CAM16 8 1 2 3 4 5 e A B d c _RV 16 book Seite 8 Freitag 13 April 2007 2 33 14...
