PerfectView CAM24, CAM27
Mounting the camera
31
8.2
Mounting the camera
Note!
If installing the camera alters the vehicle height or length specified
in the vehicle documents, your vehicle must be inspected by the
appropriate authorities.
Make sure that you are in possession of documents verifying that
your vehicle has passed this inspection.
Warning!
Select a location for the camera and attach it so securely that
it cannot under any circumstances fall off and injure bystanders
(e.g. by being knocked off by branches brushing over the roof of
the vehicle).
Observe the following installation instructions:
z
To provide a suitable viewing angle, the camera must be attached at
a height of at least 2 m.
Ensure that you have a firm place from which to work when mounting
the camera.
z
Ensure that the installation location of the camera is sufficiently firm
(e.g. to prevent the camera from being knocked down by branches that
may brush over the roof of the vehicle).
z
Mount the camera horizontally and in the middle of the rear of the vehicle
(Fig.
a
, page 6).
z
The most secure type of attachment is with screws fitted through the
body. Please observe the following instructions:
– There must be sufficient space for the mounting procedure behind the
chosen installation location.
– Suitable measures must be taken to prevent water penetrating through
any holes made (e.g. by using screws and sealant and/or spraying the
outer attachment parts with a sealant).
– The location on the body where you wish to attach the camera must
be rigid enough to allow the camera to be tightly fastened.
z
Check beforehand that there is sufficient room for the drill head to come
out on the other side (Fig.
2
, page 4).
z
If you are not sure about the location you have chosen, consult the vehicle
manufacturer or dealer.
_RV-24N_RV-27N.book Seite 31 Montag, 4. Juni 2007 11:42 11
