PerfectView CAM24, CAM27
Mounting the camera
33
Creating a through-hole for the camera connection cable
(Fig.
e
, page 6)
Note!
If possible, use available openings – such as ventilation grilles – to
feed the connection cables through. If there are no existing open-
ings, you must drill a hole with a 13 mm diameter.
Check beforehand that there is sufficient room for the drill
head to come out on the other side.
➤
Drill a hole of Ø 13 mm near the camera.
➤
Deburr all drill holes that have been made in the sheet metal and apply
rust-protection.
➤
Place cable sleeves in all sharp edged ducts.
Attaching the camera and camera guard
➤
Push the camera into the camera bracket (Fig.
8
2, page 5).
Caution!
Only use the screws supplied to mount the camera in the camera
bracket. Longer screws will damage the camera.
➤
Secure the camera
loosely
with the two screws M3 x 6 mm in the middle
threaded drill holes (Fig.
f
, page 6).
The camera is now centred.
➤
Align the camera so that the lens is at an angle of approx. 50° to the
perpendicular axis of the vehicle (Fig.
g
, page 7).
Caution!
Never mount the camera without the additional camera guard.
To mount the camera guard, only use the supplied M3 x 8 mm
screws. Longer screws will damage the camera.
➤
Push the camera guard (Fig.
8
3, page 5) over the camera in such a way
that the central drill holes slide over both screw heads and the slots are
aligned with those of the camera bracket.
You can now see the two threaded drill holes for securing the camera
guard and the camera bracket.
_RV-24N_RV-27N.book Seite 33 Montag, 4. Juni 2007 11:42 11
