WAERATOR WA-A01, User Manual

06

Section 4.

It is highly recommended that you run clean water through the Waerator before using it in order to clear out 

any dust or debris that may have settled inside the spout or nozzle during shipping. 

Remove the cover, place 4 AAA batteries into the battery compartment.
Replace the cover then take an empty wine bottle and fill it with clean water.
Connect the tube to the Waerator by pressing the end with the cap onto the nozzle.
Place the Waerator over the mouth of the bottle making sure to thread the tube though the neck.
Place a glass or other container under the Waerator’s spout.
Press and hold the button to use the Waerator. Continue until all the water has been used up.
Repeat this process at least 3 times to fully wash out the Waerator.

Step1.
Step2.
Step3.
Step4.
Step5.
Step6.
Step7.

Cleaning the Waerator

Use a dry, non-abrasive cloth to gently remove debris and/or wipe the outside of the Aerator.
Never spray liquid directly onto any part of the Aerator. Only wine and water may only come in direct contact with the tubes, nozzle, and 

injection openings.
After cleaning the Aerator, allow 24 hrs drying time. Check all parts before reinstalling. 
Never use cleaning solutions. Only water may be used during cleaning.
Do not expose the Aerator’s Electric parts to water, moisture, or liquids. If water enters the Electric parts of the Aerator, these components 

may sustain serious internal damage. 

WAERATOR

TM 

Instant Wine Aerator User’s Manual