WAFER GSM-KEY REMOTE CONTROL UNIT
http://www.waferstar.com
This is used to setup the phone number that is used to update the device inside working clock
You will receive a Acknowledge with:
#PWD123456#TIMER-UPDATE: 96754667 OK
#PWD123456#CLOCK ( Only the Timer update phone number can be effective with this )
That is used to update the device clock with the specified update phone number
Acknowledge
: CLOCK UPDATE TO 2010-10-18,16:58:10
#PWD123456#OUT1=ON
This is used to control the outpt switch to ON
Your will receive the Acknowledge as
:
OUT1 ON okay
#PWD123456#OUT1=OFF
This is used to control the outpt switch to OFF
Your will receive the Acknowledge as
:
OUT1 OFF okay
PC Software interface:
Software language select
Select the right language according to your county,wafer will update the language step by setp.
(When Distributor need to support your local language,please contact wafer company)
COM Port parameters config interface and connect to the device
Before program the device through the PC,firstly you need to config the COM port paramters and
then connect the device to PC software.
Password is the PWD password, if no change,the initial password is “ 123456 ”
In the is program mode selection area, you have three type of the program mode to select
