C-700 Series
Digital Locking
Modular Assembly Manual
1
Slide cylinder into assembly holder.
Loosen all screws
on bridge with
flathead screwdriver.
5
Tighten screw
of connect body set on
Reader Knob part and Inner Knob part
with Phillips screwdriver.
Length Adjustment
Parts list for Tool Kit
2
6
Assemble three parts: Reader Knob
part, Cam, and Inner Knob part.
3
Take apart cylinder into three sections:
Reader Knob part, Cam, and Inner Knob
part.
7
4
Select a specified length connect body
set
or combination with screws
for
Reader Knob part and Inner Knob part.
★
Please refer to Length Assembly Diagram
for connect body set selection.
★
There is size indicator on the bridge
8
Tighten bridge screws
with flathead
screwdriver.
Connect Bodies and pins:
5mm x 12, 10mm x 12, and 15mm x 4
Bridges: 30/35 x 6, 35/35 x 6, 35/40 x
6, 40/40 x 6, 40/45 x 3, and 45/45 x 3
Connect Body Set Screws: 35mm x
18, 40mm x 18, and 45mm x 6
Bridge Screws: 50pcs
Reader Knob Screws: 50pcs
Steel Balls: 50pcs
Anti-pulling Pins: 20pcs
Anti-drilling Pins: 20pcs
Seal Rings inside Reader Knob: 10pcs
Assembly Holder: 1pc
Knob Cap Assembly Tool: 1pc
Slightly turn reader knob and inner knob
to fit into cam.
Put steel balls
back to the original
position.
Select appropriate bridge and assemble it.
WFE TECHNOLOGY CORPORATION
Tel: 886-4-22300362 Fax: 886-4-22377995
No. 16 Ke Yuan 2nd Rd., Central Taiwan Science Park
Taichung city 407, Taiwan.
E-mail: info@waferlock.com
body
pin
Remove bridge
from the top of
cylinder carefully. There are two steel
balls
in between. Please keep steel
balls
in a container to prevent from
loss during the length adjustment.
Reader Knob
Cam
Inner Knob
