A. Fasten two stick screws
to reader case.
B. Pull the inside control unit cables through plate.
C. Connect cables between control unit and mortise.
Slide the mortise into the door, and please be careful.
if the cable is clipped or connector is disconnected.
A. Fasten the plate and front reader with screws.
B. Fasten the mounting screw.
A. Stuff the extra cables into the door.
B. Slide the control unit from the bottom up and
fasten it on the plate.
C. Fasten the mounting screw for the control unit.
A. Install the ANSI cylinder.
B. Fasten the slide cover screws.
A. Place spring cage onto outside lever assembly
with arrows pointing in direction of lever rotation.
Insert spindle into hub of lock case.
B. Position outside lever assembly into post holes
of lock case.
A. Insert spindle into hub of lock case.
B. Place spring cage with arrows pointing in direction
of lever rotation and mounting plate(spring-mount
assembly) onto lock case and fasten with screws.
C. Cap inside rose over spring-mount assembly.
D. Insert inside spring into lever hole and tighten inside
lever bushing with spanner wrench.
E. Insert turn piece assembly and fasten with screws.
Fasten the mortise screws and cover by side plate
A. Pull the front reader cable through the door and
on top of mortise. Stick screws match the holes
on the door.
B. Connect cables between the front reader and
control unit.
21
21
10
14
13
13
10
24
24
18
L342
Installation Manual
www.waferlock.com
1
3
20
20
25
25
Outside Lever
Inside Lever
23
23
A
22
22
13
10
11
17
18
18
17
19
9
12
12
15
