WEL-7103 Duo Electronic Lock User Manual
Combination of lock modes
Standard
Toggle
Single
This is a manufacturer
default setting. When the
lock is in St Single
mode, the lock will open
for 6 seconds then close.
When lock is in
Single mode, the lock will
switch between “always
open” and “always close”
when a valid user code is
entered or valid user card is
flashed.
Dual
When the lock is in
st dual mode, the
lock will require user to
flash a valid user card then
enter a valid user code to
access the lock.
When the lock is in Toggle
+ Dual mode, the lock will
switch between “always
open” and “always close”
when flashing a valid user
card then enter a valid user
code.
Reset the lock Master Code back to 123456 without deleting all users
1. Hold and press * and # button
2. Remove the battery case away from lock
3. Install back the battery case
4. Red & Green LED will blink
5. Enter a valid user code or flash a valid user card
6. After long beep the master code will be return back to default value: 123456
Opening the door by User Card
1. Approach the reader by user card
2. If the card is legal (learned), beep 1 time, flash 1 time green LED for 1 second.
3. If the card is illegal (not learned), beep 2 times, flash 2 times red LED, then
standby.
Opening the door by User Code
1. Press * button
2. Press previous learned user code, then press # button.
1. If enter less than 4 digits, beep 2 times, flash 2 times red LED, then standby.
2. If code already exists, beep 2 times, flash 2 times red LED, then standby.
3. If code is learned, beep 1 time, flash 1 time green LED for 1 second.
2011. Nov 3
