background image

Portable 2 Way Jumpstarter by Wagan Tech 

USER’S MANUAL — Please read before using this equipment. 

________________________________________________________________________________________________________________________________________________________________

www.wagan.com

© 2004 Wagan Corporation. 

All Rights Reserved. 

Wagan and Wagan.com are trademarks used by Wagan Corporation. 

2

Thank you for purchasing the Portable 2 Way Jumpstarter by Wagan 
Tech.  With normal care and proper treatment it will provide years of 
reliable service. Please read all operating instructions carefully 
before use. 

IMPORTANT:

PRIOR TO USE, READ AND UNDERSTAND ALL WARNINGS, 
CAUTIONS AND INSTRUCTIONS INCLUDED IN THIS 
INSTRUCTION MANUAL, AND THOSE PUBLISHED BY YOUR 
VEHICLE BATTERY MANUFACTURER AND MANUFACTURER OF 
ANY DEVICE INTENDED TO BE USED WITH THIS UNIT. RETAIN 
THESE INSTRUCTIONS FOR FUTURE REFERENCE. 

CONTROLS:

 

FIRST AID: 

Make sure fresh water and soap are available nearby in case battery acid 
contacts skin, eyes or clothing. If contact with battery acid occurs, rinse 
immediately and thoroughly with water. Then wash with soap and water. 
Obtain immediate medical attention if redness, irritation or pain is present. 
For eye contact, flush eyes for at least 15 minutes and obtain medical 
attention.

CAUTIONS:

- Always keep the clamps in their storage covers to prevent sparking 
  when they are not in use. 

-

 

Do not recharge product battery with damaged chargers. Replace 
chargers immediately 

-

 

Do not attempt to remove or replace the battery used in this 
device. When the battery has reached the end of it’s useful 
lifetime, take the entire unit to a battery recycling facility 

-

 

Avoid dropping metal tools onto vehicle battery. It may spark or 
short-circuit the battery or other electrical part that may cause short 
circuits or explosion 

-

 

For proper and safe operation of the 12 volt DC power accessory 
outlets, do not place anything into it except the plug of the 
accessory to be used 

-

 

Do not place anything into AC charging input socket except the 
provided plug from charger unit 

-

 

Remove metal personal jewelry, such as rings, bracelets, 
necklaces and watches while working with a lead-acid battery. It 
can produce a short-circuit that may cause severe burns 

-

 

Never charge or jump-start a frozen battery 

-

 

Never allow clamps (positive & negative terminals) to touch 
together or to connect the same piece of metal to prevent short-
circuits and arcing 

-

 

Do not operate this device while wearing vinyl clothing. Static 
electricity may be generated when vinyl clothing is rubbed 

-

 

This product is not intended for use in the rain or temperatures 
above 130°F 

Different size adapters 

for various valves

Front view

5 Watt 

built-in flashlight 

built-in flashlight
ON/OFF switch 

12 Amp hour

seal battery

Charge level 

indicator button

Charge level indicator
Red - battery low, 
          charging needed
Green - battery full

Jumper

safety protector

400 Amp 

heavy duty

booster clamps

AC adapter for recharging

(included)

12V cigarette lighter

outlet adapter

(included)

12 Volt Outlet

Summary of Contents for 2 Way Jumpstarter






Reviews: