Portable 2 Way Jumpstarter by Wagan Tech
USER’S MANUAL — Please read before using this equipment.
________________________________________________________________________________________________________________________________________________________________
www.wagan.com
© 2004 Wagan Corporation.
All Rights Reserved.
Wagan and Wagan.com are trademarks used by Wagan Corporation.
5
7. Turn the jumper safety protector to “Horizontal” position to
activate the jumper. Turn the switch back to “Vertical”
position to turn off the jumper when finished charging.
USING THE AIR COMPRESSOR:
CAUTION:
Check item to be inflated for manufacturer’s maximum
recommended inflation pressure. Avoid over inflation. Most tires are
properly inflated between 24-35 PSI. Some truck and bicycle tires
require 40 PSI or more.
To inflate tires:
1. Remove valve cap from air valve stem
Note:
Make sure locking thumb lever is at up position. If
necessary, use valve stem adapter
2. Insert stem connector to valve stem
Note:
Make sure connector is pushed to valve stem as far
as possible
3. Press down the locking thumb lever to engage
4. Set the compressor on/off switch to “ON” position by
pressing down the section of switch marked “I”
Note:
In the event that the tire is completely flat, raise the
vehicle using a recommended jack before inflating the tire
5. Monitor pressure on air pressure gauge
Note:
It is recommended to use a separate air gauge to
check the actual inflation pressure. When desired pressure is
reached, turn off compressor, turn the locking thumb lever to
up position and remove stem connector from valve stem.
Also remove the valve stem adapter if applicable
6. Replace valve cap on valve stem
To inflate plastic inflatable product (balls, air mattresses, rubber rafts, etc.):
1. Check manufacturer’s specification on item to be inflated for
correct inflation pressure
2. Remove valve cap cover from valve stem
3. Insert proper valve stem adapter into stem connector as far as
possible and turn the locking thumb lever to down position
4. Insert other end of valve stem adapter into inflatable air valve stem
as far as practical
5. Set the compressor on/off switch to “on” position
6. Monitor pressure on air pressure gauge. When desired pressure is
reached, turn off compressor, turn the locking thumb lever to up
position and remove stem connector from valve stem. Also remove
valve stem adapter if applicable. Replace valve cap on valve stem
STORAGE:
This unit may be stored in any position. Make sure the clamps are secure
inside the booster cable storage covers. Store at room temperature. If not
used for a prolonged period of time, recharge every 2 months in the winter
and every month in the summer.
SPECIFICATIONS:
Power Supply Battery:………….……12AH sealed lead acid, maintenance
free, spill-proof and rechargeable.
Power Supply DC Output:…………..12-volts nominal.
Air Compressor:………………………275 PSI
Power Supply Boost Rate:…………..650 amp peak
Power Supply Charging Time:………24 hours for the first time charging
with AC charger; 20 hours to recharge
with AC charger; 6-8 hours to
recharge with 12-volt DC charger.
