R
500 Peak amp Jumpstarter with air compressor by Wagan Tech
0
©2009 Wagan Corporation. All Rights Reserved.
Wagan and wagan.com are trademarks used by Wagan Corporation.
Uncover the dust cover from the Power Port.
Insert the 2V DC accessory plug into the Power Port.
Set the On/Off safety switch to the “ON” position.
Set the power port On/Off switch to the “ON” position by pressing
down the section of the switch marked “I”.
Operate the appliance as usual.
After use, set the power port On/Off switch to the “OFF” position by
pressing down the section of the switch marked “O”.
Disconnect the accessory plug from the Power Port and store the
accessory.
Replace the Power Port’s dust cover.
Recharge the unit as soon as convenient.
UsB POWeR PORT
Set the On/Off safety switch to the “On” position. A USB Power Port located
underneath the charging jack can power/charge devices that require 5 Volts at
up to 500mA through the use of a user-supplied cord.
sTORaGe
This unit may be stored in any position. Make sure the clamps are secure inside
the booster cable storage covers. Store at room temperature. If not used for
a prolonged period of time, recharge every 2 months in the winter and every
month in the summer.
.
2.
.
4.
5.
.
.
8.
.
