USER’S MANUAL — Please read before using this equipment.
© 2007 Wagan Corporation.
All Rights Reserved.
Wagan and Wagan.com are trademarks used by Wagan Corporation.
3
Bluetooth Headset 2566
By Wagan Tech
ACTIVATING THE Bluetooth
MAKING A CALL WITH THE HEADSET ON
You must activate your Bluetooth to establish a Bluetooth connection between
your mobile phone and other Bluetooth devices. Go the Menu Key by pressing
the joystick. Scroll to Connect, press YES to SELECT. A list of options will be
displayed. Choose Bluetooth press YES to connect the Bluetooth link. (Please
refer your mobile phone user's manual for establishing connection with
Bluetooth device)
Normal dialing
1. Enter the contact number and press SEND/ANS button on the phone. Audio
is automatically transferred to the Headset.
2. Press the ON/OFF (1) button to hang-up and terminate the call.
Voice dialing
Step 1. When the Headset is under linked state, press the VOLUME UP (2)
button to activate the voice dialing.
PAIRING TO THE CELLULAR PHONE
Step l. Pressing ON/Off (1) button more than 6 seconds to turn on Bluetooth
Headset, then keep pressing it for more than 2 seconds till a red light and blue
light blinking simultaneously, and it goes to pairing mode when a short and a
long sounds are heard.
Step 2. A beep will then be heard on the Headset prompting the user to say the
name of the person to call.
Step 3. Say the name. Then, the name will be played back to you. The phone
will then place the call automatically. In case the cell phone does not recognize
the spoken name, the steps above need to be repeated.
Step 2. Please look up to user's manual to proceed with Bluetooth Headset
pairing mode.
Step 4. Press the ON/OFF (1) button again to terminate the call. Note: Voice
dialing control needs mobile phone support, please look up to your user's
manual of mobile phone.
Step 3. Bluetooth Headset asks for putting pairing code 1234, and press
confirm button (1234 is preset code). When pairing is done, a red light turns
off and a blue light blinking.
Note: If pairing with mobile phone can't be done within about 3 minutes,
Headset will close pairing mode. (If pairing has to be done, please repeat step
1- step 3)
REDIALING
Press quickly the ON/OFF (1) button twice to activate the last dialed out
telephone number.
ANSWERING/RECEIVING A CALL
When the phone is receiving a call, a ring tone will be heard on the Headset.
REJECTINGA CALL
1. Just press the ON/Off (1) button down once to answer the call. Pressing the
button again will hang-up and terminate the call.
Press the ON/OFF (1) button more than 2 seconds to refuse the incoming call.
2. To terminate the call, simply press the ON/OFF (1) button again.
SETTING THE VOLUME
Volume setting can be done during calls only.
1. Press VOLUME UP (2) to increase volume
www.wagan.com
4
