©2023 Wagan Corporation. All Rights Reserved.
Wagan Tech and
wagan.com
are trademarks of Wagan Corporation.
User’s Manual—Read before using this equipment
2
INSTALLATION
For installation with DC to DC chargers only:
1. Locate the 4-pin connector attached to the DC to DC Charger.
2. Remove the plastic dust cover from the 4-pin connector.
3. Connect the 4-pin connector from the connection cable to the DC to DC
charger. Secure this connection by threading the 2 ends of the cable
together.
Cut an opening in the mounting surface based on the dimensions shown below:
MOUNTING THE DISPLAY
4. Connect the red wire attached to the connection cable to any 12V source in
the vehicle – this will be used to power the display.
Note: if the inverter will also be used with the display, connecting this red
wire is not necessary.
5. Feed the connection cable into the vehicle where you want to mount the
display.
4”
2.2”
(2)
“ @4.5”
18
