Digital Remote Interface by Wagan Tech
®
3
www.wagan.com
For installation with the inverter only or both DC to DC charger and inverter:
1. Locate the RJ45 to RJ45 cable included with the remote display.
2. Connect the RJ45 cable to the inverter remote port at one end and the
remote display at the other end.
3. Turn the power switch on the inverter to “remote” setting.
4. The inverter on/off function is controlled by the remote display.
5. Note: When the inverter is connected to the remote, the remote will receive
power from the inverter, so the red wire on the DC to DC charger
connection cable does not need to be connected. Tape off this wire to
avoid accidental contact with conductive surfaces.
6. Follow instructions in the previous section “DC to DC chargers only” above
to install the DC to DC Charger, skipping step #4.
6. Connect the RJ45 end of the cable to either port on the remote display.
