©2016 Wagan Corporation. All Rights Reserved.
Wagan Tech and
wagan.com
are trademarks used by Wagan Corporation.
User’s Manual—Read before using this equipment
14
• Isolate the television, its power cord and antenna cables from the 12
volt power source by running an extension cord from the inverter to the
television set.
Troubleshooting
PROBLEM: Low or No Output Voltage – Fault LED Lit
Reason
Solution
Poor contact with battery or inverter
terminals.
Clean terminals thoroughly. Reinstall
and tighten.
PROBLEM: Inverter is Shut Down – Fault LED Lit
Reason
Solution
Battery voltage below 10 Volts
Charge or replace battery.
Inverter is too hot (thermal shut down
mode).
• Allow inverter to cool.
• Check for adequate ventilation.
• Reduce the load on the inverter to
rated continuous power output.
Unit may be defective.
See warranty and call customer
service.
PROBLEM: Inverter Shut Down – Fault LED Lit – OVL Display
Reason
Solution
Equipment being operated draws too
much power.
Use a higher capacity inverter or do
not use this equipment.
PROBLEM: Continuous Buzzing Sound – Display Shows Low Voltage
Summary of Contents for Elite 2000W
Page 19: ......
