EN
G
LIS
H
©2018 Wagan Corporation. All Rights Reserved.
Wagan Tech and
wagan.com
are trademarks of Wagan Corporation.
11
User’s Manual—Read before using this equipment
Warning lights
Type of warning
Solution
Flashing red
light
Car battery is
already charged
Call mechanic. Dead battery is not the reason your car
won’t start.
No light
Battery too low,
short-circuit, or
reverse-polarity
Disconnect iOnBoost immediately. Press button and
follow connection procedure again.
USING THE DC POWER SOCKET
For proper and safe operation of the DC power socket, do not place anything into it except the plug
of the accessory to be used.
Overloading the port may result in “tripping” a self-resetting circuit breaker. Removing the overload
automatically restores power to the DC socket.
1. Insert DC plug of the accessory you wish to use. Power will be automatically supplied.
2. Do not use jumpstart feature while DC socket is in use.
3. Recharge the iOnBoost as soon as convenient.
USING THE USB SOCKETS
If the charge in the iOnBoost is low, the USB ports will shut off to prevent damage to
the iOnBoost.
1. Insert USB plug of the device you wish to charge.
2. Tap the
button.
3. Do not use jumpstart feature while either USB socket is in use.
4. Recharge the iOnBoost as soon as convenient.
LED FLASHLIGHT
The light will automatically shut off before the iOnBoost runs out of power.
1. Hold down the
button until the flashlight turns on (~3 seconds).
2. Press once to switch lighting modes: steady – flashing – SOS – off.
3. Recharge battery as soon as convenient.
PROPER DISPOSAL
• This product has no consumer serviceable parts.
• Do not attempt to remove or replace the battery used in this device. When the battery has
reached the end of its lifetime, please take the entire unit to a battery recycling facility.
