©2021 Wagan Corporation. All Rights Reserved.
Wagan Tech and
wagan.com
are trademarks of Wagan Corporation.
User’s Manual—Read before using this equipment
7
TROUBLESHOOTING
Code
Cause
Solution
F1
Internal Failure
Do not use
F2
Internal Failure
Do not use
F3
Temperature to low to
charge
Charge unit in warmer place
F4
Internal Failure
Check that adapter is >5V 1A. If not, use a
different charge adapter. If the adapter is
already >5V 1A, do not use.
INFLATOR
Air Pressure
units
Air Pressure
Target setting
Current
Air pressure
1. Connect the valve connector to the valve stem of the tire.
2. Press and hold the Power Button for 3 seconds.
3. Press the Air Pressure Unit Button to toggle between Bar, KG/cm2 and PSI.
4. If desired, set the pre-set tire pressure function with the “+” and “-” Air Pressure Setup
Buttons.
5. Press the Inflator button to start air flow.
6. If not using the pre-set tire pressure function, press the Inflator Button a second time to turn
the inflator off once the desired pressure is reached.
7. If using the pre-set tire pressure function, the inflator will stop automatically once the set
pressure is reached.
8. Remove valve connector from valve stem.
Allow the unit to cool for 15 minutes after each 10 minutes of use.
Summary of Contents for iOnBoost V8 Air
Page 21: ......
